Inspect a Forklift
There are more than 10,000 workplace injuries related to forklifts occur each year, according to HRSDC and OSHA reports. Many of these mishaps are caused by driver error. Lack of appropriate equipment maintenance and inspection results in numerous others. Forklift maintenance and operation is not just the cause of personal injuries, but also of property damage. Forklifts could damage overhead pipes, sprinklers and building structures, and other equipment when improperly operated. The following day by day check ups must be performed in order to reduce the likelihood of forklift accidents.
Turn off the engine before checking different fluid levels: engine oil, fuel, hydraulic oil, coolant and brake fluid. The tires should be inspected for signs of wear and tear. Check the air pressure in the tires. Check the forks' condition. The load backrest should be attached tightly. Do a visual inspection of the top-clip retaining pin and heel. Then carry out an inspection of the mast chains, hydraulic hoses, stops and cables. Make sure that both the overhead and finger guards are firmly attached.
LP forklifts have propane tanks that have to be inspected for signs of rust, corrosion or damage. Test the battery's charge and electrolyte levels. All belts should be inspected for wear. Check to make certain the owner's handbook is kept on-board the forklift in a storage compartment. Test the seat belt to make sure the latches are secure. Check the hood latch to make certain that it is working as it should.
Start the forklift and listen to the engine noise to make sure there are no unusual sounds. If there are, investigate at once. Check the accelerator and the steering controls. The parking break and the service break must be functioning properly.
To ensure proper functioning in both forward and reverse, the drive control and tilt control should be inspected. The functioning of the hoist, the lowering control and attachment control needs periodic inspection. Check the horn and lights. Afterward check the defroster, wipers and heater to make sure they are working well. Check each and every gauge to ascertain that it is reading within functional limits.