Change a Propane Tank
Propane powered forklifts are commonly utilized in warehouses. The forklift is designed with the propane tank mounted at the rear of the driver. The tanks, which look a lot like beer kegs, need to be replaced from time to time since they have a limited lifespan. Forklift operators must use caution when handling propane tanks. Compressed gases are really hazardous, especially because the gas is flammable. Always use caution when replacing and removing propane tank to prevent being injured.
1 To change a propane tank, first stop the forklift while leaving the engine running, and turn the valve on the tank off. Let the lift truck run until the engine dies. This procedure burns off the gas inside the transfer hose which connects the engine and the tank. Prior to taking the next steps, wear the correct safety equipment, like insulated gloves made of either neoprene or leather. It is very important for you to protect your skin from contact with the compressed gas, that is very cold.
2 The tank hose has to be disconnected, followed by removing the tank from its holding straps. When putting in a new tank, reconnect the holding straps and reattach the hose at the valve of the tank by tightening the nut.
3 You could check for leaks by applying soapy water to the valve and opening it slightly. Leaking gas would cause bubbles to froth around the value. If this happens, inspect the connection hose at the nut and the valve area. Re-tighten the connecting nut if you detect any leaks in the area of the valve, and after that do the leak checking process all over again. Persistent leaks mean that both the nut and connecting hose must be replaced. Nevertheless, if replacing the hose and nut still does not stop the leak, the tank must be replaced.
4 Open the valve all the way to allow the gas to fill the connecting hose. Then you could start the forklift and continue working.